PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual DF40, DF50 Fuel Line [97][Df40, Df50]

Related Products:
Service Manual DF40, DF50 Fuel Line [97][Df40, Df50]
99500-87J08-01E
Suzuki Marine

REMOVAL / INSTALLATION

Pay special attention to the following steps when removing or installing fuel hoses.

The components after the high pressure fuel pump remain pressurized at all times. To protect against fuel spray, relieve fuel line pressure before disconnecting or removing components.

• Do not over bend (kink) or twist hoses when installing.
• When installing hose clamps, position tabs to avoid contact with other parts.
• Be sure hoses do not contact rods, levers or other components with engine either operating or at rest.
• Extreme care should be taken not to cut, abrade or cause any other damage to hoses.
• Use care not to excessively compress hoses when tightening clamps.

• Check fuel hose routing. (See page 10-7 and 10-9)
• Check for fuel leakage.

FUEL LEAKAGE CHECK PROCEDURE

After performing any fuel system service, always be sure there is not fuel leakage by checking as follows.

  1. Squeeze fuel primer bulb until you feel resistance.
  2. Turn ignition switch “ON” for 3 seconds(to operate fuel pump), then turn it “OFF”. Repeat this (ON and OFF) procedure 3 or 4 times to pressurize the fuel system.
  3. Once pressurized, check all connections and components for any signs of leakage.
Share on social:

Related Products