ELECTRONIC FUEL INJECTION SYSTEM
FUEL INJECTION TIMING CHART
- Fuel injection timing is always fixed at BTDC 425° on exhaust stroke.
- The fuel injection time duration (amount) is varied by the condition of engine running.
- Angles indicated in the following chart show CRANKSHAFT angle.

CONTROL MODE
BEFORE START :
When the ignition switch is turned “ON”, the ECM receives a MAP sensor signal, indicating the static barometric pressure of the intake manifold, which is used to compensate the fuel injection map for altitude.
WHEN CRANKING :
Fuel is simultaneously injected to all cylinders every time any piston is positioned at compression stroke.
AFTER START (FAST-IDLE FUNCTION):
The fuel injection amount is controlled to increase until the timer, set according to cylinder temperature at the time of engine start, expires.
WHEN IDLING / TROLLING :
The fuel injection amount is controlled to maintain a stable engine speed at the specified idle / trolling rpm.
WHEN ACCELERATING :
The fuel injection amount is controlled to increase.
WHEN DECELERATING :
The fuel injection amount is controlled to decrease.
The fuel injection is also cut off on very rapid engine deceleration.
