PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual DF40, DF50 Cylinder Compression [40][Df40, Df50]

Related Products:
Service Manual DF40, DF50 Cylinder Compression [40][Df40, Df50]
99500-87J08-01E
Suzuki Marine

CYLINDER COMPRESSION

Cylinder compression :

Standard : 1300 – 1600 kPa (13 - 16 kg / cm2, 185 – 228 psi.)
Max. difference between any two cylinders : 100kPa (1.0 kg / cm2 , 14 psi.)

Figures shown are guidelines only, not absolute service limits.

Low compression pressure can indicate one or more of the following :

  • Excessively worn cylinder wall
  • Worn piston or piston rings
  • Stuck piston rings
  • Poor seating of valves
  • Ruptured or otherwise damaged cylinder head gasket

TEST PROCEDURE

(1) Start engine and allow to warm up, then shut engine off.

(2) Remove the STBD / PORT engine side lower cover.

(3) Remove all spark plugs.

(4) Install the compression gauge into the plug hole.

TOOL 09915-64512 : Compression gauge
09915-63210 : Compression gauge adaptor

(5) Disconnect the safety lanyard (switch plate) from the emergency stop switch.

Disconnect the safety lanyard from the emergency stop switch prior to cranking the engine.
This will prevent any residual fuel discharged from the cylinders being ignited by a spark discharge from the ignition coil.

(6) Disconnect the remote control throttle cable from the throttle lever.

(7) Move and hold the throttle lever in the full-open position.

(8) While cranking the engine with the starter motor, note the maximum compression pressure reading on the gauge for each cylinder.

(9) Reinstall parts removed earlier. ( spark plug, side lower cover, etc.)

Share on social:

Related Products