CRANKCASE BOLT
The surface treatment of the crankcase bolt has been changed. The tightening of the case bolts is performed in three stages. However, with this change effected, the torque specification for the second tightening stage has been changed. The torque specifications for the first and the final tightening remains unchanged.
Crankcase bolt tightening torque
2nd step 10 mm 37 N·m → 23 N·m
2nd step 8 mm 20 N·m → 13 N·m
CRANKCASE TO CYLINDER
Clean mating surface of cylinder and crankcase.
Apply sealant to mating surface of crankcase as shown.
Apply sealant to mating surface only.
Do not allow sealant to contact surface of bearing.
99000-31140: Suzuki Bond 1207B

- Install four (4) dowel pins (1).

Install crankcase to cylinder.
Apply engine oil to crankcase bolts.
Tighten crankcase bolts in three (3) steps following the order indicated below.

After tightening crankcase bolts, check to be sure that crankshaft rotates smoothly when turned by hand.
Crankcase bolt
1st step 8 mm 5 N·m (0.5 kg-m, 3.5 lb.-ft.)
10 mm 10 N·m (1.0 kg-m, 7.0 lb.-ft.)
2nd step 8 mm 13 N·m (1.3 kg-m, 9.5 lb.-ft.)
10 mm 23 N·m (2.3 kg-m, 16.5 lb.-ft.)
Final step 8 mm 25 N·m (2.5 kg-m, 18.0 lb.-ft.)
10 mm 46 N·m (4.6 kg-m, 33.5 lb.-ft.)

