PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual DF40, DF50 Cleaning And Inspecting [171][Df40, Df50]

Related Products:
Service Manual DF40, DF50 Cleaning And Inspecting [171][Df40, Df50]
99500-87J08-01E
Suzuki Marine

Disassembly of tilt rod / piston assembly

Unscrew the piston retaining nut from the bottom of the tilt rod and remove the washer.

Carefully retain and account for four shock valves, each com posed of a spring, rod and ball.

Remove the piston assembly and PTT cylinder head from the tilt rod by sliding them down and off the rod end.

CLEANING AND INSPECTING

Thoroughly wash all metal components with cleaning solvent and dry them with compressed air.

Arrange all components on a clean sheet of paper.

Do not lay PTT components out on a rag, as dirt or lint may be transferred to these items which may cause possible system operating problems.

Inspect tilt rod, replace if damaged or bent.

Inspect the surface of tilt rod for scores, grooves or roughness. Slight roughness may be removed with fine emery paper. A badly scored or grooved rod must be replaced.

Inspect the PTT cap seal and O-ring.

Replace if cuts, nicks, or excessive wear is found.

It is recommended that the O-ring always be replaced once the tilt cylinder has been disassembled.

Inspect the shock valves (spring, rod and ball). Replace if there are any signs of rust or pitting.

Inspect the cylinder bore for evidence of a rough or grooved surface.

Light honing may rectify slight surface roughness or scarring, but a deeply scarred surface will require replacement of the tilt cylinder.

Inspect all O-ring (manual release valve and main check valve). Replace if nicked or cut.

Share on social:

Related Products