PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual DF40, DF50 Air Intake Components [57][Df40, Df50]

Related Products:
Service Manual DF40, DF50 Air Intake Components [57][Df40, Df50]
99500-87J08-01E
Suzuki Marine

AIR INTAKE COMPONENTS

Air, after entering through the silencer, passes through the throttle body and flows into the surge tank where it is then distributed to the cylinder intake manifold.

Intake manifold pressure, monitored by the MAP sensor, is an indirect measure of the intake air amount. When the throttle is fully closed, the main supply of intake manifold air necessary to sustain engine idle passes through the by-pass air passage.

To maintain engine idle speed at specification, the ECM controlled IAC valve supplies a regulated amount of additional air through the IAC (idle air control) passage.

THROTTLE BODY

The throttle body assembly consists of the main bore, throttle valve, by-pass air passage, IAC passages, by-pass air screw and CTP swicth.

The throttle body adjusts the intake air amount with the throttle valve which is connected to the throttle / linkage lever.

The CTP (closed throttle position) switch installed on the top of throttle body informs of throttle valve position.

Do not try to adjust or remove any of the throttle body component parts (CTP switch, throttle valve, throttle / linkage lever, etc. ).
These components have been factory adjusted to precise specifications.

BY-PASS AIR SCREW / PASSAGE

Since the throttle valve is almost fully closed when idling/ trolling, the main flow of air necessary to maintain idling /trolling speed passes through the by-pass air passage.

The by-pass air adjustment screw controls the flow of air through the passage and provides a means of partially adjusting the total amount of air necessary for idling /trolling.

See page 2—14 for the by—pass air screw adjustment procedure.

IAC VALVE / PASSAGE

The IAC valve is a solenoid plunger type mounted on the electrical parts holder.

Its purpose is to control the amount of intake air flowing from the IAC passage.

The IAC valve is driven by the duty cycle signal from the ECM.

IDLE AIR CONTROL SYSTEM

OUTLINE

The ECM controls the duty cycle signal of the IAC valve to regulate a portion of the intake air flow to the intake manifold.

This system is used for the following purposes:

  • To keep idling /trolling at the specified speed.

  • To improve driveability when decelerating.

(Dash-pot effect)

  • To improve engine starting and warm-up performance.

(Fast-idle function)

The sensors / switch shown below monitor current engine condition and send signals to the ECM. Based on these signals, the ECM determines the optimum duty cycle (repeating “ON” time rate within a cycle).

A repeating ON/OFF signal at a specified rate (10 times a second) is then sent to the IAC valve.

Share on social:

Related Products