EXTENSION SERVICE – V4 MODELS
Removal
Remove six screws retaining extension.

- Screws
Remove extension.
Remove grommets and seal.
Installation
Apply Adhesive 847 to the shift rod and water tube flange of the extension. Install new grommets.
Apply Triple-Guard grease to outer grommet surfaces.
Apply Adhesive 847 to the bottom flange of the extension. Install a new seal.
Apply Triple-Guard grease to outer seal surface.

- Adhesive 847
- Triple-Guard grease
Install extension with six screws and tighten to a torque of 18 to 20 ft lb. (24 to 27 N•m).
STERN BRACKET
Stern Bracket Disassembly
Before servicing the stern bracket:
- Remove gearcase. Refer to Gearcase GEARCASE REMOVAL AND INSTALLATION on p. 294.
- Remove powerhead. Refer to Powerhead POWERHEAD REMOVAL on p. 220.
- Remove exhaust housing. Refer to Exhaust Housing Exhaust Housing Removal on p. 268.
- Remove power trim/tilt unit. Refer to TRIM AND TILT section.
Remove and discard steering shaft locknut.

Remove the lower mount bracket and keeper.


