Troubleshooting
Before working on the engine, check that hull, rigging and engine installation are normal, and then battery is fully charged. For mechanical troubleshooting, refer to relevant troubleshooting section in this chapter. For checking and servicing the machine, refer to service procedures described in this manual to perform the works safely.
State 1 Engine will not start
**





Engine starts but stalls soon
- Inspection of Fuel System, Ignition System, Compression Pressure.



Idle engine speed will not stabilize
- Inspection of Intake Manifold, Air Intake System and Ignition System.

Rapid opening of throttle fails acceleration
Rapid opening of throttle causes engine to stall. (Stops.)
Acceleration is not smooth.
- Inspection of Carburetor, Ignition System and Compression Pressure.

Gear shifting cannot be made normally

