PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual 5008740_200-300 HP 90 ° V Electrical And Ignition [Ignition Coil Servicing]

Related Products:
Service Manual 5008740_200-300 HP 90 ° V Electrical And Ignition [Ignition Coil Servicing]
5008740
BRP Marine

IGNITION COIL SERVICING

Ignition Coil Removal

Remove spark plug lead from ignition coil.

Disconnect ignition coil electrical connector.

Remove two ignition coil retaining screws.

Do not lose the rubber washers between coil and bracket.

  1. Screws
  2. Connector

Ignition Coil Bracket Removal

Remove all ignition coils from bracket.

Remove spark plug lead ground screw.

  1. Ground screw

Remove four screws and bracket.

  1. Screws

Ignition Coil Bracket Installation

Install bracket with four screws. Tighten screws to a torque of 60 to 84 in. lb. (7 to 9.5 N·m).

Install spark plug leads with ground screw. Tighten screw securely.

Ignition Coil Installation

Connect ignition coil electrical connector. Place electrical connector on its retainer.

Install one rubber washer on each screw . Inst all screw through ignition coil. Install remaining rubber washers on screws between coil and bracket.

  1. Electrical connector
  2. Rubber washers

Install coil with washers on bracket.

Tighten screws to a torque of 60 to 84 in . lb. (7 to 9.5 N·m).

Install spark plug lead on ignition coil.

Share on social:

Related Products