PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual 5008332_115-200 HP 60° V4-V6 Routine Service [Spark Plugs]

Related Products:
Service Manual 5008332_115-200 HP 60° V4-V6 Routine Service [Spark Plugs]
5008332
BRP Marine

Routine Service

  • Single Ram System–Add Evinrude/Johnson Biodegradable TNT Fluid, as needed, to bring level to the bottom of the fill plug threads.


008017
Single Ram System, 115 - 130 HP

  1. Fill cap

Install the filler cap and tighten to a torque of 45 to 55 in. lbs. (5 to 6 N·m).

  • Disengage tilt support.

  • Cycle the unit at least five complete cycles to purge all air from the system. When cycling the unit, hold the trim switch ON an additional 5 to 10 seconds after the unit reaches the end of its travel before activating the switch in the opposite direction.

Spark Plugs

Spark plugs should be removed and examined periodically. Replace worn, fouled or damaged spark plugs.

Use only recommended spark plugs with the correct gap setting.

Spark Plug, Champion
QC10WEP @ 0.028 ± 0.003 in. (0.71 mm)
  • Remove spark plugs and inspect condition.

  • Set spark plug gap on new, replacement spark plugs.

  • Mark spark plugs for ground electrode orientation.

  • Apply Electrical Grease to the ribbed portion of the spark plug ceramic and to the opening of the spark plug cover to prevent corrosion.

  • Install spark plugs using “indexing” procedure.

Indexing

Spark plug indexing positions the ground electrode of the spark plug opposite the fuel injector nozzle.

Put an ink mark on the ceramic of the spark plug in line with the OPEN side of the ground electrode. This mark will be used to orient the spark plug with the OPEN side of the ground electrode facing the fuel injector.


000758

  1. Ink mark
  2. Open side

Apply Triple-Guard grease to the gasket surface of the spark plug. Install spark plug and tighten to a torque of 15 ft. lbs. (20 N·m).

If the mark is in unshaded area do not tighten anymore.


004294
Spark Plug Indexing Diagram

  1. Unshaded area
  2. Shaded area

If the mark is in the shaded area, reset torque wrench to 30 ft. lbs. (41 N·m) and continue to turn until the mark is in the unshaded area.

If the mark does not reach the unshaded area before the torque of 30 ft. lbs. (41 N·m) is reached, the spark plug cannot be indexed for that cylinder. Try another spark plug and repeat the steps above.

Fuel and Oil System

Routine replacement of filters reduces the possibility of foreign material restricting the incoming fuel or oil supplies.

Replacement filter elements are available through Evinrude/Johnson Genuine Parts.

Fuel Filter

Evinrude E-TEC V-model outboards are equipped with a water-sensing, water-separating fuel filter. Refer to FUEL COMPONENT SERVICING on p. 146.


005237

  1. Water-separating fuel filter
Share on social:

Related Products