PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Service Manual 5008330_55 HP MFE Manual Starter [Recoil Starter Disassembly]

Related Products:
Service Manual 5008330_55 HP MFE Manual Starter [Recoil Starter Disassembly]
5008330
BRP Marine

RECOIL STARTER REMOVAL

To prevent accidental starting while servicing, twist and remove all spark plug leads.

Remove the clamp holding the oiling system wiring harness.

Remove the three starter housing screws and washers.

    1. Clamp
    1. Starter housing screws (3)

Lift starter housing from outboard.

Remove three screws and remove starter ratchet from flywheel.

    1. Ratchet

RECOIL STARTER DISASSEMBLY

Wear safety glasses while disassembling and assembling manual starters because of rewind spring tension.

Pull the starter rope out far enough to tie a slip knot in the rope. Remove the end of the starter rope from the handle anchor and remove the han dle. Release the slip knot and ease the rope back in until the rewind spring is fully unwound. If nec essary, remove the starter handle bracket from the starter housing.

    1. Slip knot
    1. Rope anchor

Remove the rope guide and pulley support from the starter housing.

    1. Rope guide 007854
    1. Pulley support

Remove the nut from the starter pawl retaining screw.

    1. Nut

Remove the starter pawl retaining screw, washer, and starter pawl plate with plate return spring from the starter assembly.

    1. Screw
    1. Washer
    1. Plate
    1. Spring

Remove starter housing spring and starter pawl with spring washer from the starter assembly.

    1. Spring
    1. Starter pawl
    1. Spring washer (under starter pawl)

Use a screwdriver to pry open the pulley lock ring, and remove ring from the starter.

    1. Lock ring

Remove the friction plates and friction plate spring washer.

    1. Friction plates
    1. Friction plate spring washer

Hold the pulley in the starter housing while turning the starter over, legs down. Hold fingers clear of the pulley and jar the starter housing against a bench to dislodge the rewind spring and pulley. Remove the pulley bushing from the pulley.

Share on social:

Related Products