Step 1: TILT TUBE
Step 2: Removal
Support the outboard with a suitable hoist.
Pull locking tabs on tilt limit cam loose from collar.

- Locking tabs
Remove the cam and collar from the tilt tube.
Remove the nut from the starboard side.
Thread the spacer from Tilt Tube Service Kit, P/N 434523, onto the starboard end of the tilt tube.
Remove steering cable wiper nut from tilt tube. Thread the adapter from Tilt Tube Service Kit, P/N 434523, onto the port end of the tilt tube.
Thread Slide Hammer, P/N 432128, into the adapter until at least 2 in. (51 mm) of thread are engaged.
Pull tilt tube from stern bracket with the slide ham mer. When tilt tube clears the port stern bracket, remove tilt tube from the spacer.
Step 3: Installation
Thread starboard end of tilt tube into the spacer.
Thread the adapter onto port end of tilt tube.
Use a wood or leather mallet to tap the tilt tube into position.
Make sure the lock tab is in correct position.

- Lock tab
Install the starboard locknut.
Replace locknut if definite resistance is not felt.
Torque starboard tilt tube nut to 50 to 54 ft. lbs. (68 to 73 N·m), then loosen nut 1/8 to 1/4 turn.

Replace steering cable wiper nut on port end of tilt tube.
Apply one drop of instant bonding adhesive in receiving channels of tilt limit switch collar and install collar and tilt cam on tilt tube. Be sure locating tab on collar fits in hole on tilt tube.

