PRESSURE RELIEF VALVE SERVICING
The pressure relief valve assembly should be serviced at the same time as the thermostats.
Disassembly
Remove hose clamps and hoses from pressure valve.

- Hoses
Remove screws securing the bracket to powerhead. Remove the pressure valve housing.
Remove the bracket and the cap from the housing. Remove the pressure valve assembly.

- Bracket
- Cap
Inspection
Inspect all components for cracks, heat damage, or signs of corrosion. Replace damaged components. Clean all debris from pressure relief valve components.
Assembly
Assembly is essentially the reverse of disassembly.
Pay close attention when performing the following additional tasks.
Torque bracket and cap screws to 60 to 84 in. lbs. (7 to 9.5 N-m).
Install valve on powerhead. Torque nuts to 60 to 84 in. lbs. (7 to 9.5 N-m).
Install hoses and secure with clamps.
