TROUBLESHOOTING
Use the following guidelines to check a single piston trim/tilt unit that is not working correctly.
Cylinder Leakdown:
Manual release valve seals
External leaks
No reverse lock:
- External leaks
No operation, motor runs:
Manual release valve open
Fluid level low
Pump coupler
Hydraulic pump
No tilt down:
Manual release valve
Fluid level
Slow performance:
Manual release valve
Fluid level low
Mechanical binding
Electric motor
Hydraulic pump
Unit locked in tilt up:
Mechanical binding
Hydraulic pump
ELECTRICAL CIRCUIT TESTS
Relay Testing
When the trim-UP button is pressed, the UP relay is energized and connects the blue trim motor wire to the battery positive (+) terminal. The green trim motor wire remains grounded. When the button is released, the blue trim motor wire returns to a grounded position.
When the trim-DOWN button is pressed, the DOWN relay is energized and connects the green trim motor wire to the battery positive (+) terminal. The blue motor wire remains grounded. When the button is released, the green trim motor wire returns to a grounded position.
Refer to TILT/TRIM RELAY TEST on p. 138 for relay testing procedure.
Trim and Tilt Motor Current Draw Tests
Careful analysis of the electric motor's current draw and trim/tilt unit operating speed aids evaluation of the electric motor and certain mechanical components.
Use a battery rated at 360 CCA (50 Ah) or higher that is in good condition and fully charged to per form this test.
IMPORTANT: The specifications contained in the Performance Chart are for static hydraulic tests. DO NOT attempt to perform the following tests while the boat is moving.
