MANUAL STARTER
Turn housing over and tap on bench to remove spring.

Keep fingers away from uncoiling spring.
Do NOT remove spring with housing facing up. Do NOT lift spring out of housing by hand or with pliers.
Spring is under tension and will cause injury if accidentally released.
Remove two screws. Remove the rope guide.

- Screws
RECOIL STARTER CLEANING AND INSPECTION
Wash metal components in solvent and dry with compressed air.
Inspect the rewind spring for broken end loops and weak tension.
Examine the starter pawl for wear.
Inspect the starter components for wear. Replace as necessary.
Inspect starter rope. Replace rope if frayed. Cut new rope 80 in. (203 cm) in length. Fuse ends of rope to a length of 1/2 in. (12 mm).
Examine the pulley and the starter housing. Look for sharp edges and rough surfaces that could fray the starter rope. File and polish to remove.
Examine the starter. Replace any worn or damaged parts.
