REPLACEMENT POWERHEAD INSTALLATION SEAL KIT P/N 5008973
This seal kit is applicable to 2009 and newer 15 – 30 HP Evinrude® E-TEC® models only. Some
components may not be used on your specific model. Refer to appropriate parts catalog for specific
|325951||Washer, Flywheel nut - M16||1|
|353298||Gasket, Exhaust housing to powerhead||1|
|353316||Gasket, Reed plate to crankcase||1|
|353317||Gasket, Throttle body to reed plate||1|
|5007419||Spark Plug (QC10WEP)||2|
|5007895||Kit, Injector Seal||2|
Important Installation Procedures
Install the impeller assembly. Refer to the instructions provided with the impeller assembly.
Failure to install the impeller assembly could result in an engine overheat.**
Index all spark plugs. Refer to “Spark Plug Indexing” in service manual for proper spark plug installation
Use Evinrude Diagnostics Software to confirm engine management software is current. Update
engine management software if needed. Refer to “Software Replacement” in service manual.
Use Evinrude Diagnostics Software to initiate powerhead break-in oiling. Refer to “Powerhead
Break-In” in service manual.
Use Evinrude Diagnostics Software to set TPS Calibration. Refer to “TPS Calibration” in service
Prime fuel system. Refer to “Fuel System Priming” in service manual for proper fuel priming procedures.
Prime oiling system. Refer to “Oil System Priming” in service manual for proper oil priming procedures.
Use Evinrude Diagnostics Software to perform timing verification. Refer to “Timing Verification” in
Use Evinrude Diagnostics Software to engine operating temperature. Refer to “Engine Temperature
Check” in service manual.