PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Contact Us
Overstock
Up to 50% off
Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment
Where is my model number?

Remote Control Conversion Kit

Repair Time: 30 to 60 mins
Repair Difficulty: Easy
added updated
Remote Control Conversion Kit
BRP Marine Outboard

SAFETY

These installation instructions contain information that can help prevent personal injury and damage to equipment. Understand the following symbols before proceeding:

Alerts you to the possibility of danger and identifies information that will help prevent injuries.

Identifies information that will help prevent damage to machinery.

Appears next to information that controls correct assembly and operation of the product.

TO THE OWNER

The assembly procedures outlined in this sheet should be performed by a skilled technician. If you have questions, see your DEALER. Save these instructions in your owner's kit. This sheet contains information important to the future use and maintenance of your engine.

TO THE INSTALLER

Give this sheet to the owner. Advise the owner of any special operation or maintenance information contained in the instructions.

Preface

PREFACE

This kit converts a 1995 (EO) and newer 9.9/15 four-stroke tiller model to remote shift and throttle operation.

[1]

Contents of Kit

Ref. Name of Part Qty.
1 Connector 1
2 Shift Link 1
3 Spring Clip 3
4 Retainer 1
5 Screw 1
6 Grommet 1

Installation of this kit involves procedures described in detail in your Service Manual.

Remove stop switch clip to prevent accidental starting.

Remove lower engine covers.

[2]
Thread connector (1) onto shift link (2) until tight.

[3]

Install shift link on shift lever and retain with spring clip **(3).

Install remote control cables as described in service manual.

[4]
Install spring clips (3) to secure cables.

[5]
Install retainer (4) and screw (5). Tighten screw to 60-84 in. lbs. (7-9 Nm).

[6]
Install lower engine covers. then install new grommet (6) on cables and position it in cover.

Verify that controls work as intended for safe operation.

5007742 - Remote Control Adapter

0176494 - Remote Control Adaptor Kit

Share on social: