PRIMER BULB AND HOSE KIT - P/N 5008693, INSTALLATION INSTRUCTIONS
Use this primer bulb and hose kit on portable fuel tanks requiring a 5/16 inch diameter fuel hose.
The following symbols and/or signal words may be used in this document:
Indicates a hazardous situation which, if not avoided, WILL result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, CAN result in severe injury or death.
Indicates a potentially hazardous situation which, if not avoided, MAY result in minor or moderate personal injury or property damage. It also may be used to alert against unsafe practices.
Indicates an instruction which, if not followed, could severely damage engine components or other property.
These safety alert signal words mean:
YOUR SAFETY IS INVOLVED!
For safety reasons, this kit must be installed by an authorized Evinrude/Johnson® dealer. This instruction sheet is not a substitute for work experience. Additional helpful information may be found in other service literature.
DO NOT perform any work until you have read and understood these instructions completely.
Torque wrench tightening specifications must strictly be adhered to.
Should removal of any locking fastener (lock tabs, locknuts, or patch screws) be required, always replace with a new one.
When replacement parts are required, use Evinrude/Johnson Genuine Parts or parts with equivalent characteristics, including type, strength and material. Use of substandard parts could result in injury or product malfunction.
Always wear EYE PROTECTION AND APPROPRIATE GLOVES when using power tools.
Unless otherwise specified, engine must be OFF (not running) when performing this work.
Always be aware of parts that can move, such as flywheels, propellers, etc.
Some components may be HOT. Always wait for engine to cool down before performing work.
If you use procedures or service tools that are not recommended in this instruction sheet, YOU ALONE must decide if your actions might injure people or damage the outboard.
This instruction sheet may be translated into other languages. In the event of any discrepancy, the English version shall prevail.
TO THE INSTALLER: Give this sheet and the operating instructions to the owner. Advise the owner of any special operation or maintenance information contained in the instructions.
TO THE OWNER: Save these instructions in your owner’s kit. This sheet contains information important for the use and maintenance of your engine.
PRIMER BULB AND HOSE ASSEMBLY
|5008693||PRIMER BULB AND HOSE ASSEMBLY|
Use caution when working on any fuel system. Wear safety glasses and work in a well ventilated area. Extinguish all smoking materials and make certain no open flames or ignition sources exist. Fuel is flammable and can be explosive under certain conditions.
Remove plastic plug.
Apply Pipe Thread Sealing Compound on to fitting of fuel hose.
Install fuel hose, do not over tighten.
Install fuel hose quick disconnect on to outboard’s fuel connector.
Open vent screw, turn counterclockwise.
Hold primer bulb with arrow pointing up and toward the direction of fuel flow. Squeeze until firm.
Inspect fuel system for leaks. Repair any leaks.