PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Power Unit [Power Unit Removal And Installation] [2002]

Related Products:

Applicable Models

Model group Year Model Serial
Yamaha Outboard 1996 - 2002 5hp All
Yamaha Outboard 1996 - 1999 4hp All

Power Unit [Power Unit Removal And Installation] [2002]
LIT-18616-01-33
Yamaha Marine

PREPARATION FOR REMOVAL

  • Remove the top cowling.
  • Remove the fuel tank and hose. Refer to the “FUEL SYSTEM” section in CHAPTER 4.
  • Remove the carburetor.
    Refer to the “FUEL SYSTEM” section in CHAPTER 4.

NOTE ON REMOVAL AND REASSEMBLY

Extent of removal: (1) Power unit removal

  • Clean all dirt, mud, dust and foreign material from the engine before the engine is removed and disassembled.
  • To ensure that you can perform the work cleanly and efficiently, check that you have the proper tools and cleaning equipment before commencing engine removal and reassembly.

REMOVAL POINTS

Start-in-gear protection wire (For start-in-gear protection model)

  1. Remove:
    • Clip (1)
    • Link (2)

Stop switch/Engine stop switch lead

  1. Remove:
    • Black (B) lead (1) (ground lead)
  2. Disconnect:
    • White (W) lead (2)
  3. Remove:
    • Stop switch (3)

Ignition coil bracket

  1. Remove:
    • Bolt (1)
    • Spark plug cap (2)
    • Ignition coil bracket (3)

ASSEMBLY AND INSTALLATION

Always use new gaskets, oil seals and O-rings. The use of any used oil seal or O-ring may result in oil leakage due to invisible scratches or stretches.
Apply grease to parts where specified.

Power unit

  1. Apply:
    • Gasket Maker
      Onto both faces of the gasket.

Clean the contacting surfaces of crankcase and bottom cowling.

  1. Install:
    • Dowel pin (1)
    • Gasket (2) (new)

  1. Install:
    • Power unit (1)

Insert the drive shaft into the crankshaft. If the splines will not come in complete mesh, rotate the crankshaft a little so that they are in mesh correctly.

  1. Install:
    • Mount bolt (1)
    • Mount bolt (2)

Tighten the bolts in two steps of torque.

Mount bolt:
1st : 3 Nm (0.3 kg•m, 2.2 ft•lb)
2nd : 8 Nm (0.8 kg•m, 5.8 ft•lb)

  1. Install:
    • Stop switch/Engine stop switch (1)
    • White lead (2)
    • Black lead (3)
  1. Install:
    • Link (1)
    • Clip (2)
  1. Adjust:
    • Throttle wire
      Refer to the “PERIODIC SERVICE" section in CHAPTER 3.
  1. Adjust:
    • Idle speed
      Refer to the “PERIODIC SERVICE” section in CHAPTER 3.
Share on social:

Related Products