EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART
| Step | Procedure/Part name | Q'ty | Service points |
|---|---|---|---|
| ELECTRICAL UNIT REMOVAL | Follow the left "Step" for removal. | ||
| Fuel pump | |||
| Carburetor unit | |||
| 1 | Engine stop switch ground lead (EH, EHT) | 1 | |
| 2 | CDI unit | 1 | |
| 3 | PTT relay (ET, EHT) | 1 |
EXPLODED DIAGRAM

| Step | Procedure/Part name | Q'ty | Service points |
|---|---|---|---|
| 4 | Ignition coil | 1 | |
| 5 | Spark plug lead | 2 | |
| 6 | Rectifier-regulator | 1 | NOTE:The aluminum side of the rectifier-regulator must face the engine block. |
| 7 | Ground lead | 2 | |
| 8 | Pulser coil | 1 | |
| 9 | Engine temperature sensor | 1 | |
| 10 | Oil pressure switch connector | 1 | |
| 11 | Oil pressure switch | 1 |
EXPLODED DIAGRAM

| Step | Procedure/Part name | Q'ty | Service points |
|---|---|---|---|
| 12 | Starter relay | 1 | |
| 13 | Ground lead | 3 | |
| 14 | Starting motor | 1 | |
| 15 | Wire harness | 1 | |
| Reverse the removal steps for installation. |
