PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Periodic Inspection And Adjustment [General] [1998]

Related Products:

Applicable Models

Model group Year Model Serial
Yamaha International 1998 25hp All
Yamaha Outboard 1998 25hp All

Periodic Inspection And Adjustment [General] [1998]
LIT-18616-01-77
Yamaha Marine

Anode

  1. Inspect:
    • Anode
    • Trim tab
      Scales → Clean.
      Oil/grease → Clean.
      Excessive wear → Replace.

Do not oil, grease or paint the anode, or it will not operate properly.

Battery

Battery electrolyte is dangerous; it contains sulfuric acid which is poisonous and highly caustic.
Always follow these preventive measures:
• Avoid bodily contact with electrolyte as it can cause severe burns or permanent eye injury.
• Wear protective eye gear when handling or working near batteries.
Antidote (EXTERNAL):
• SKIN - Wash with water.
• EYES - Flush with water for 15 minutes and get immediate medical attention.
Antidote (INTERNAL):
• Drink large quantities of water or milk followed with milk of magnesia, beaten egg or vegetable oil. Get immediate medical attention.
Batteries generate explosive, hydrogen gas. Always follow these preventive measures:
• Charge batteries in a well-ventilated area.
• Keep batteries away from fire, sparks or open flames (e.g., welding equipment, lighted cigarettes, etc.).
• DO NOT SMOKE when charging or handling batteries.
KEEP BATTERIES AND ELECTROLYTE OUT OF REACH OF CHILDREN.

● Batteries vary among manufacturers. Consult your battery manufacturer's instructions.
● First, disconnect the negative lead, then the positive lead.

  1. Check:
    • Battery fluid level
      Below the minimum level mark → Add distilled water to the proper level.
    • Battery fluid specific gravity
      Less than 1.280 → Recharge the battery.

        Battery fluid specific gravity: 1.280 at 20 C (68 F)

Spark plugs

  1. Inspect:
    • Electrodes (1)
      Cracks/excessive wear → Replace.
    • Insulator color (2)
      Distinctly different color → Check the engine condition.

        Color guide:
            Medium to light tan color:
                Normal
            Whitish color:
                • Lean fuel mixture
                • Pluggedjet(s)
                • Air leak
                • Wrong setting
            Blackish color:
                • Rich mixture
                • Defective ignition system
                • Excessive idling
                • Wrong spark plug

  1. Clean:

    • Spark plugs
      (with a spark plug cleaner or wire brush)
  2. Measure:

    • Spark plug gap (a)
      Out of specification → Regap

        Spark plug gap: 0.9 mm (0.04 in)

  1. Tighten:
    • Spark plugs

        Spark plug: 17.2 Nm (1.7 m•kg, 12.6 ft•lb)

● Before installing the spark plug, clean the gasket surface and spark plug surface. Also, it is suggested to apply a thin film of anti-seize compound to the spark plug threads to prevent thread seizure.
● If a torque wrench is not available, a good estimate of the correct tightening torque is to finger tighten (a) the spark plug and then tighten it another 1/4 to 1/2 of a turn (b).
● Always use a new spark plug gasket.

Lubrication points

  1. Apply:
    • Water resistant grease
Share on social:

Related Products