PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Owner's Manual DF40, DF50 Inspection Before Boating

Related Products:
Owner's Manual DF40, DF50 Inspection Before Boating
99011-87J09-03A
Suzuki Marine

INSPECTION BEFORE BOATING

To ensure the safety of all occupants, always conduct the following inspection before beginning your trip.

It is important to make sure that your boat and motor are in good condition and that you are properly prepared for an emergency.

Always perform the following checks before you begin boating:

  • Check that you have enough fuel for the intended run.

  • Check the level of engine oil in the sump.

Running the engine with insufficient oil can cause serious engine damage.

To check the oil level:

To avoid an incorrect assessment of engine oil level, check the level only when the engine has cooled.

  1. Place the motor in a vertical position, then remove the motor cover (1) by unlocking the lever (2).

  1. Pull out the oil dipstick and wipe oil off with a clean cloth.

If the engine oil is contaminated or discolored, replace with fresh engine oil. Refer to the ENGINE OIL section.

  1. Insert the dipstick all the way into the engine, then remove it again.

The oil on the dipstick should be between the upper and lower limits shown on the dipstick. If the oil level indication is near the lower limit, add enough oil to raise the level to the upper limit.

To fill the engine with oil:

  1. Remove the oil filler cap.

  2. Fill with recommended engine oil to the upper level.

Do not overfill, as excessive oil can damage the engine.

  1. Tighten the oil filler cap securely.
  • Check the battery solution level.

The level should be kept between the MAX and the MIN level lines at all times. If the level drops below the MIN level line, refer to MAINTENANCE section.

  • Make sure that the battery leads are securely connected to the battery terminals.

  • Visually check the propeller to make sure it is not damaged.

  • Make sure the motor is securely mounted to the transom.

  • Check for proper operation of the Power Trim and Tilt. (Remote control model)

  • Make sure the tilt pin is securely installed in the proper position.

  • Check for proper trim angle.

  • Make sure you have the boating safety and emergency equipment on board.

FUEL RESERVE

The total capacity of the fuel tank is 6.6 gallons including a reserve of about 1 gallon. When the fuel remaining in the tank reaches approximately 1 gallon, the active chamber will run dry and the motor will begin to stall. To use the reserve fuel, first turn the motor off. Tighten the
vent screw on the fuel tank cap and tip the fuel tank as shown in the illustration to pour the remaining fuel from the reserve chamber to the
active chamber. Open the vent screw, prime the fuel line and restart the motor.

Share on social:

Related Products