WATER TEST AND FINAL ADJUSTMENTS
An in the water test is required to make sure the outboard(s) and boat are rigged correctly, propeller selection is correct, and that all accessories function properly.
Pay special attention to the following, especially if the boat is repowered with new outboard(s):
• Engine mounting height
• Correct propeller selection and WOT RPM
Make all needed adjustments or repairs and retest before delivery.
When ready for delivery, give all instruction sheets, operating instructions and user guides provided with accessories to the owner. Advise the owner of any special operation or maintenance information contained in the instructions.
IMPORTANT: Complete the Predelivery Check list and obtain owner’s signature at the time of delivery. The Predelivery Checklist must be kept on file for seven years.
Break-In
Evinrude 4-Stroke outboards require break in. When the outboard is delivered, refer the customer to the Break In information in the Operator’s Guide.
Follow this procedure to protect the outboard during its initial hours of operation. Careful break-in allows internal engine components to “seat” properly, resulting in maximum engine performance.
Failure to carefully follow the break-in procedures can result in engine damage.
- **First 10 minutes of operation ** Operate the engine in gear at idle only.
2.Next 50 minutes Operate engine in gear below 3000 RPM. DO NOT hold a constant throttle setting. Change engine speed every 15 minutes.
- Second Hour Use full throttle to accelerate boat onto plane, then reduce throttle setting to half. BE SURE the boat remains on plane at this throttle setting.
At ten minute intervals, apply full throttle for periods of one minute, Return to half throttle for a cooling period.
Change engine speed every 15 minutes.
- Next Eight Hours Operate engine in gear below 4000 RPM. Use full throttle to quickly accelerate boat onto plane. Immediately reduce throttle to three–quarters or less, as soon as the boat is on plane. BE SURE the boat remains on plane at this throttle setting.
At ten minute intervals, apply full throttle for periods of one to two minutes. Return to three–quarters throttle for a cooling period.
Change the engine speed every 15 minutes.
DO NOT exceed recommended maximum engine RPM. Refer to Engine Specifications in the out board Operator’s Guide.
Trim Tab Adjustment
Improper trim tab adjustment can cause difficult steering and loss of control.
A propeller will generate steering torque when the propeller shaft is not running parallel to the water’s surface. The trim tab is adjustable to compensate for this steering torque.
IMPORTANT: A single trim tab adjustment will relieve steering effort under only one set of speed, outboard angle and load conditions. No single adjustment can relieve steering effort under all conditions.
If the boat pulls to the left or right when its load is evenly distributed, adjust the trim tab as follows:
• With the remote control in NEUTRAL and the engine OFF, loosen the trim tab screw.
• If the boat pulled to the right, move rear of the trim tab slightly to the right.
• If the boat pulled to the left, move rear of the trim tab slightly to the left.
Tighten the trim tab screw to 5 ft. lbs. (6 N·m).

- Trim tab screw
Test the boat and, if needed, repeat the procedure until steering effort is as equal as possible.
A Predelivery Checklist is included in the owner’ s package of every outboard. Use the Predelivery Checklist to ensure a complete predelivery is performed on each Evinrude inspection
4-Stroke outboard before the outboard is delivered to the owner or the operator.
Refer to the Sample Predelivery Checklist on p. 52.
Dealers are required to perform a complete predelivery inspection on each outboard. Outboards installed by boat manufacturers also require a complete predelivery inspection
Always reference Evinrude and Johnson publications to support required installation procedures. Dealers MUST keep predelivery checklists on file for a minimum of seven years. As part of ongoing dealer evaluations, your BRP representative may ask to see dealer service records to confirm the use of predelivery checklists.
Dealer predelivery programs should include additional inspections related to the boat, boat accessories and the trailer.
