PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Lower Unit Overhaul [Preparation For Removal] [1986]

Related Products:
Lower Unit Overhaul [Preparation For Removal] [1986]
LIT-18616-00-06
Yamaha Marine

DESCRIPTION

The exhaust gases emitted from both right and left cylinder banks join together in the center of the banks, and flow through the exhaust guide and exhaust pipe.

Then, the gases expand in the muffler and are finally forced out into water.

At low speeds (idling and trolling), the exhaust pressure is low and also the upper casing is under water down to its center so that smooth exhaust of gases will be impossible.

To make smooth exhaust at low speeds, the upper part of the exhaust pipe is provided with a hole through which the exhaust gases are forced out into the muffler.

The exhaust gases further flow through the labyrinth at the front of the muffler and stream into the water between the upper case and muffler.

Then the gases flow out of the water and, through the labyrinth at the rear of the upper case, finally they stream out of the upper case.

These two labyrinths and expansion chamber are very effective in reducing the exhaust noise.

The cooling water circuit is an open type and thus the engine is always cooled by new
water.

The impeller in the water pump is keyed to the drive shaft so that the water flow rate is controlled depending on the engine speed.

The gear case has both forward and reverse gears (spiral bevel gears) and a clutch dog. By sliding the clutch dog back and forth by moving the plunger, the rotating direction of the propeller is changed.

If disassembly of the lower unit or bracket unit is required, it is necessary to remove the power head assembly. (Refer to power head removal page 4-2)

PREPARATION FOR REMOVAL

  1. All dirt, salt, dust, and foreign material must be cleaned from the engine before the lower unit is removed and disassembled. This will help keep foreign material out of the lower unit.

  2. Before lower unit removal and disassembly, be sure that you have the proper tools and cleaning equipment. With them you can perform a clean and efficient job.

  3. During lower unit disassembly, clean all parts and place them in trays in their order of disassembly. This will speed up assembly and help assure that all parts are correctly reinstalled in the lower unit.

  4. Before disassembling the gear case, drain the gear oil into a tray. Use care not to spill the oil on the floor.

  5. When disassembling the lower unit, use a repair stand.

Share on social:

Related Products