Measuring the forward and reverse gear backlash
Remove the water pump assembly.
Set the gearshift to the neutral position.

Shift rod push arm: YB-06052
- Install the special service tool so that it pushes against the propeller shaft.

NOTE:
Tighten the universal puller or center bolt while turning the drive shaft until the drive shaft can no longer be turned.
Bearing housing puller (1): YB-06207
Universal puller (2): YB-06117
Install the backlash indicator onto the drive shaft (22.4 mm [0.88 in] in diameter), then the dial gauge onto the lower unit.
Set the lower unit upside down.

NOTE:
Install the dial gauge so that the plunger (a) contacts the mark (b) on the backlash indicator.
Backlash indicator gauge (3): YB-06265
Magnetic plate (4): YB-07003
Dial gauge (5): YU-03097
Magnet flexible stand (6): YU-34481
- Slowly turn the drive shaft clockwise and counterclockwise and measure the backlash when the drive shaft stops in each direction.
Forward gear backlash: 0.21-0.44 mm (0.008-0.017 in)
- Add or remove shim(s) if out of specification.
| Forward gear backlash | Shim thickness |
|---|---|
| Less than 0.21 mm (0.008 in) | To be decreased by (0.33- M) x 0.71 |
| More than 0.44 mm (0.017 in) | To be increased by (M-0.33) x 0.71 |
M: Measurement
Available shim thicknesses: 0.10, 0.12, 0.15, 0.18, 0.30, 0.40, and 0.50 mm
Remove the special service tools from the propeller shaft.
Apply a load to the reverse gear by installing the propeller (7), the spacer (8) (without the washer (9)), then the washer (10) as shown.

NOTE:
Tighten the propeller nut (11) while turning the drive shaft until the drive shaft can no longer be turned.
- Slowly turn the drive shaft clockwise and counterclockwise and measure the backlash when the drive shaft stops in each direction.

Reverse gear backclash: 0.70-1.03 mm (0.028-0.041 in)
- Add or remove shim(s) if out of specification.
| Reverse gear backlash | Shim thickness |
|---|---|
| Less than 0.70 mm (0.028 in) | To be decreased by (0.87- M) x 0.71 |
| More than 1.03 mm (0.041 in) | To be increased by (M-0.87) x 0.71 |
M: Measurement
Available shim thicknesses: 0.10, 0.12, 0.15, 0.18, 0.30, 0.40, and 0.50 mm
- Remove the special service tools, and then install the water pump assembly.
