PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Fuel System [Carburetor] [1998]

Related Products:

Applicable Models

Model group Year Model Serial
Yamaha International 1998 25hp All
Yamaha Outboard 1998 25hp All

Fuel System [Carburetor] [1998]
LIT-18616-01-77
Yamaha Marine

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
CARBURETOR DISASSEMBLY 1 Follow the left "Step" for removal.
Carburetor unit
1 Throttle link rod 1
2 Electrothermal ram retainer 1
3 Electrothermal ram 1
4 O-ring 1
5 Carburetor top cover 1
6 Gasket 1
7 Pilot outletjet 1
8 O-ring 1
9 Throttle stop screw 1
10 Spring 1
Reverse the disassembly steps for installation

EXPLODED DIAGRAM

REMOVAL AND INSTALLATION CHART

Step Procedure/Part name Q'ty Service points
CARBURETOR DISASSEMBLY 2 Follow the left "Step" for removal.
Carburetor unit
1 Float chamber 1
2 Packing 1
3 Plunger rod 1
4 Rubber boot 1
5 Plunger 1
6 Spring 1
7 Circlip 1 NOt reusable
8 Ball 1
9 Float 1
10 Float pin 1

Step Procedure/Part name Q'ty Service points
11 Needle valve 1
12 Mainjet 1
13 Main nozzle 1
14 Pilotjet plug 1
15 Pilotjet 1
Reverse the disassembly steps for installation

SERVICE POINTS

Do not use a steel wire to clean the jets. This may enlarge the jet diameters and seriously affect performance.

Carburetor inspection

  1. Inspect.
  • Carburetor body

Cracks/damage -> Replace.

Contamination -> Clean.

  1. Inspect:
  • Mainjet

  • Pilotjet

  • Main nozzle

Contamination -> Clean.

  1. Inspect:
  • Needle valve

Grooved wear —> Replace.

  1. Inspect:
  • Float

Cracks/damage -> Replace.

Carburetor

  1. Install:
  • Needle valve

  • Float (1)

  • Float pin (2)

  • Screw (3)

• The float pin should fit into the slit in the carburetor and be retained with the screw.
• When installing the float into the carburetor, place the needle valve into the needle valve seat.
• After installation, make sure that the float operates smoothly.

  1. Measure:
  • Float height (a)

Out of specification -> Replace.

Float height: 10.0 ± 0.5 mm (0.39 ± 0.02 in)

• The float should be resting on the needle valve, but not compressing it.
• Take measurements at the midline of the float, opposite the side it pivots on. 4-9

Share on social:

Related Products