PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Electrical System [Lower Unit And Related Parts] [1986]

Related Products:
Electrical System [Lower Unit And Related Parts] [1986]
LIT-18616-00-06
Yamaha Marine

Choke solenoid

  1. Disconnect the choke solenoid leads from the choke solenoid and wire harness.
  2. Check the choke solenoid as specified using the pocket tester.

Continuity.................................Normal
Discontinuity.............................Defective

  1. If the element is broken, replace the entire unit.

Installation

Refer to page 4-41.

Power trim and tilt motor

Removal
Refer to page 5-18.

Disassembly

  1. Loosen the wire harness bolt, and remove the two bolts securing the frame end.
  2. Remove the commutator end by tapping on it with a plastic hammer.

1. Remove the lead wire while taking care not to break it.
2. Spray WD-40 on the lead, so the frame can easily be removed.

  1. Wire harness bolt
  2. Commutator end
  1. Remove the brushes from the brush holder, and by tapping the frame end with a plastic hammer, remove the frame end.
  2. Remove the armature from the frame end.

  1. Armature
  2. Frame end

INSPECTION AND REPAIR

Armature

  1. Check surfaces of the commutator. Using sandpaper (#500 or #600), smooth out any rough surface. If roughened excessively, turn the commutator in a lathe. If its run-out is 0.2 mm (0.008 in) or more, take the same step.
  2. Measure the commutator mica undercut. If the depth is 0.2 mm (0.008 in) or less, cut it to the specification.

Under cut: 0.4 ~ 0.8 mm (0.015 ~ 0.03 in)

  1. Check continuity between the armature coil and ground.
    If there is continuity, the armature coil is grounded and therefore, it should be replaced.
Share on social:

Related Products