PREPARE FOR WINTER: 10-50% discount on all OEM parts!

Unless prohibited by manufacturer. Does not include aftermarket or Crowley Marine branded products. Priced as marked.

Our warehouses are closed on Thursday and Friday, November 26th and 27th. Happy Thanksgiving!

Search Over 1 Million OEM Parts
Easy-to-use  parts diagrams Best price  guarantee Expert  live support 50+ years  of serving boaters Huge selection of OEM parts  -  from 1950 to 2026 Most parts in stock  -  Same day fulfillment
Most parts in stock- Same day fulfillment

Electrical System [Ignition Control System] [1998]

Related Products:

Applicable Models

Model group Year Model Serial
Yamaha International 1998 25hp All
Yamaha Outboard 1998 25hp All

Electrical System [Ignition Control System] [1998]
LIT-18616-01-77
Yamaha Marine

IGNITION CONTROL SYSTEM (E, ET)

(1) Pulser coil
(2) Oil pressure switch
(3) Engine temperature sensor
(4) Low-oil-pressure warning lamp
(5) CDI unit

B : Black
Br : Brown
P : Pink
R : Red
W : White
Br/B : Brown/Black
P/W : Pink/White
R/W : Red/White
Y/R : Yellow/Red

IGNITION CONTROL SYSTEM (EH, EHT)

(1) Pulser coil
(2) Oil pressure switch
(3) Engine temperature sensor
(4) Low-oil-pressure warning lamp
(5) CDI unit

B : Black
Br : Brown
P : Pink
R : Red
W : White
Br/B : Brown/Black
P/W : Pink/White
R/W : Red/White
Y/R : Yellow/Red

PULSER COIL

Refer to "IGNITION SYSTEM".

OIL PRESSURE SWITCH

  1. Measure:
    • Oil pressure switch continuity
    Out of specification -> Replace

Mity Vac: YB-35956/90890-06756

Oil pressure switch continuity pressure

15.5 kPa (1.55 kg/cm2,2.25 psi) and above No continuity
15.5 kPa (1.55 kg/cm2, 2.25 psi) and below Continuity

ENGINE TEMPERATURE SENSOR

  1. Measure:
    • Output voltage (at the specified temperature)
    Out of specification -> Replace.
    Refer to the following chart.

LOW-OIL-PRESSURE WARNING LAMP

  1. Check:
    • LED (Light emitting diode) lighting
    No lighting -> Replace.

Battery voltage: 1.5 V

Yellow/Red lead -> Positive terminal.
Pink/White lead -> Negative terminal.

Use a conventional AA penlight battery (1.5 V). An alkaline or higher voltage battery can burn out the diode.

LED has a direction for electrical current. Therefore try reverse connection if there is no lighting.

Share on social:

Related Products