PREPARATION FOR REMOVAL
- Remove the power unit.
- Remove the upper casing and bottom cowling.

Extent of removal:
(1) Swivel bracket removal
(2) Clamp bracket removal
(3) Swivel bracket disassembly

INSPECTION

Steering bracket and pivot shaft
- Inspect:
- Steering bracket
- Pivot shaft
Crack/Damage ➝ Replace.
Clamp and swivel bracket
- Inspect:
- Clamp bracket
- Swivel bracket
Crack/Damage ➝ Replace.

Tilt plate
- Inspect:
- Tilt plate
Crack/Damage ➝ Replace.
- Tilt plate
ASSEMBLY AND INSTALLATION

- Install:
- Drive lever (1)
- Pin (2)
- Crip (3)
NOTE :
Face the arrow mark (a) upward.

- Install:
- Spring (1)
- Tilt plate (2) (outer)
- Spring (3)
- Tilt plate (4) (inner)
- Pin (5)
- Crip (6)
NOTE:
Align the holes of the tilt plate (inner) and (outer), after installing the pin.

- Install:
- Bushing (1)
- Pin (2)

- Install:
- Clamp bracket (1)
- Friction piece (2)
- Bolt (3)
- Collar (4)
- Nut (5)

- Install:
- Bolt (1)
- Plate (2)
- Nut (3)
Nut : 7 Nm (0.7 m-kg, 5.1 ft-lb)

- Install:
- Steering shaft (1)
- Washer (2)
- Bushing (3)
NOTE:
Apply water resistant grease to steering shaft.

- Install:
- Friction piece (1)
- O-ring (2)
- Bushing (3)
- Bushing (4)

