37100-98J00 [06-26-2008]

POSITION OF THE PANEL
When selecting the switch panel position on the console, ensure the location is convenient for the opera tor and provides freedom of operator movement with the stop switch lanyard clip attached. Avoid locating the panel where water or spray is likely to splash the panel.
It is recommended that the switch panel should be installed at an angle of 10° or more off the horizontal for proper drainage.
(1) Using a hole saw and a drill bit, drill holes through the console panel at the locations as shown in Figure 1.
(2) Make sure opening is free of sharp edges.
(3) Route the wire harnesses of the switch panel to the opening.
(4) Hook up the connectors to the BCM harness by referring to the Rigging Manual.
(5) Place the switch panel into the opening. (6) Fasten the switch panel with four screws.
SUZUKI GENUINE ACCESSORIES INSTALLATION INSTRUCTIONS
Part No. | Description | Applicable mode |
---|---|---|
37100-98J00 | Panel assy, Main switch | DF300 |
1. COMPONENT PARTS
Part No. | Description | Applicable mode |
---|---|---|
1 | MAIN SWITCH | 1 |
2 | EMERGENCY SWITCH | 1 |
3 | PANEL | 1 |
4 | SCREW | 4 |
- KEY NUMBER LOCATION
2. TOOLS REQUIRED
(1) Drill
(2) 52 mm (2 1/16 in) hole saw
(3) 3.5 mm (9/64 in) drill bit
(4) Phillips + screw driver
3. IMPORTANT
WARNING/CAUTION/NOTE
Please read this manual and follow its instructions carefully. To emphasize special information, the symbol ⚠ and the words WARNING, CAUTION and NOTE have special meanings. These special meanings are applied except when laws or regulations require the signal words to be used with different meanings. Pay special attention to the messages highlighted by these signal words.
Indicates a potential hazard that could result in death or injury.
Indicates a potential hazard that could result in vehicle damage
Indicates special information to make maintenance easier or instruction clearer.
4. INSTALLATION
For complete safety, always disconnect the battery cable when removing or installing electrical equipment.
To disconnect the battery cable, first disconnect the negative (-) terminal and then the positive (+) terminal. When reconnecting, turn the main switch off, connect the positive (+) terminal and then the negative (-) terminal.
5. TEMPLATE