COVID-19 UPDATE: How Crowley Marine is preparing & responding. Read more...
flat $3.95 shipping
My Account
Order Status
Crowley Marine: serving boaters for over 50 years
Parts in stock Most parts in stock Same day fulfillment
$3.95 shipping on all orders*
Low Price Guarantee
9.6 Pilot logo
0My cart

Select Your Engine:

34660-99E00 [12-20-2002]

added
updated
Manufacturer Suzuki Marine
Sections 1

INSTALLATION INSTRUCTIONS

Description: WATER PRESSURE GAUGE SUB-KIT

Part No. and applicable model

PART NO. 34660-99E00
Description Water pressure gauge sub-kit
Applicable mode DF60T/70T

Parts in kit

Ref. Description Q'ty
(1) Hose (110mm) 1
(2) Hose (30mm) 1
(3) 3-way 1
(4) Clip 4

Installation of water pressure gauge sub kit and tube

When installing the tube and the hoses, use care to keep them out of contact with the link system including the throttle and the shift and not to bend them.

Follow the procedure described below while referring to the attached drawing.

  1. Cut the thin film of the cable grommet and pass the tube (5) through that cut and pull it inside of the engine cover. (See the figure A viewed from A.)

  2. Hook the tube (5) onto the silent cover. (See the section drawing B.)

  3. Route the tube (5) through the bottom of electric parts holder (see the section drawing C.), behind the wiring harness and beside the oil filter.

  4. Pass the tube (5) through the gap between the oil pen and the engine holder and inside cover seal (See the figure of top view D)

  5. Remove the water inspection hose connection the exhaust manifold and oil pan, Connect the hose (2) to the exhaust manifold and the hose (1) to the oil pan and then fix them with a clip () respectively.

  6. Connect the hoses (1) and (2) to the 3-way joint (3) as shown in the figure and fix them with clips (4). Then connect the tube (5) from (4) to the remaining end of the 3-way joint and fix it by fastening the band (6).

Make sure to tighten each clip and band securely.