0My cart

My cart

Cart is empty
0My cart
Crowley Marine: serving boaters for over 40 years Crowley Marine: serving boaters for over 40 years
Most parts in stock Same day fulfillment
$3.95 shipping on all orders*
Low Price Guarantee
9.6 Pilot logo
0My cart

Throttle Trunnion Connector Kit P/N 435448

Crowley Marine

Safety Considerations

These instructions will alter you to certain things you should do very carefully. If you don't, you could...

  • hurt yourself or bystanders
  • hurt boat operator, passengers
  • damage the machinery

Safety symbol, , appears next to information important to prevent you and others from being hurt.

Note symbol, Note, appears next to information important to keep machinery from being damaged.

IMPORTANT: The important safeguards and instructions appearing in these directions cannot cover all possible conditions or situations that occur. The person following these directions must use common sense, caution and care.

Product Reference & Illustration

When reference is made to brand name, product or specific tool, an equivalent product may be used in place of the referred to product. Substitute products used must have equivalent characteristics, including type, strength, and material. Incorrect substitution may result in product malfunction and possible injury to the operator and/or passengers.

All photographs and illustrations used may not necessarily depict actual models or equipment, but are intended only for reference. Specifications used are based on the latest product information available at the time of publication.
 

Preface

This kit contains a P/N 435448 throttle trunnion connector. This connector kit us used to replace P/N 334860 connector, and the P/N 321602 connector and P/N 321603 retainer (and also the original P/N 319950 throttle bracket and grommet from '74 and '75 models). This connector is used on all 9.9 and 15 model outboards with remote control.
 

Installation

[1]
Disconnect throttle cable (A) from throttle arm (B).

[2]
Remove old connector from lower motor cover by turning connector 90° clockwise. Remove retainer and connector from cable. If throttle cable goes thru a rubber grommet in lower motor cover and is attached to original bracket bolted to cover, remove grommet and bracket. Holes can be filled with P/N 334983 plugs.

[7]
If there is no square notch in bottom of cable hole (C) in front panel, file it out as shown.

[3]
The thickness of clips (D) and (E) are different to fit variable lower motor cover thickness. Remove clips from connector.

[4]
Install bottom half (with square boss) of trunnion connector (F) under the cable trunnion and fold top part (G) over on top of the trunnion.

[4] [5]
Insert cable and trunnion connector thru lower motor cover with square boss at bottom.

[3] [6]
Install the clip (D) or (E) that holds connector with least amount of looseness. Clip must fit completely to bottom of slot to properly retain connector.

[1]
Reconnect throttle cable (A) to throttle arm (B).

[5]
Adjust trunnion nut (H) as required so motor returns to idle speed.

Related Products

0435448 - Throttle Connector Kit Assembly

Flat $3.95 Shipping on ALL parts orders

We offer shipping flat $3.95 shipping on ALL parts orders. (Complete Engines, Lower Units and Sterndrives excluded). In addition orders over $89 have reduced cost express shipping available in checkout.

shipping map shipping map legend

You can get a rough idea of standard transit times from the map above.

Our boats now have their own website!

You can find all of our new and used boats at www.crowleyboats.com

Proceed to Crowley Boats

Please bookmark (crtl+d) www.crowleyboats.com for future reference.