Tab Housing Gearcase Kit P/N 433715Crowley Marine
These instructions will alter you to certain things you should do very carefully. If you don't, you could...
- hurt yourself or bystanders
- hurt boat operator, passengers
- damage the machinery
Safety symbol, , appears next to information important to prevent you and others from being hurt.
Note symbol, Note, appears next to information important to keep machinery from being damaged.
IMPORTANT: The important safeguards and instructions appearing in these directions cannot cover all possible conditions or situations that occur. The person following these directions must use common sense, caution and care.
Product Reference & Illustration
When reference is made to brand name, product or specific tool, an equivalent product may be used in place of the referred to product. Substitute products used must have equivalent characteristics, including type, strength, and material. Incorrect substitution may result in product malfunction and possible injury to the operator and/or passengers.
All photographs and illustrations used may not necessarily depict actual
models or equipment, but are intended only for reference. Specifications used
are based on the latest product information available at the time of
This Tab Housing Gearcase Kit is used to service all CR, CO, CD, CU, CE and
some ES V-6 engines. The parts included are for retaining the bearing housing in
the gearcase using tabs instead of retaining rings. Other parts from the
previous gearcase can be used unless damaged.
To the Installer
Important: The Installation of this kit requires the use of Special Service Tools and complex service procedures.
This kit should be installed by a trained service technician using current technical literature. These instructions are not intended for consumer use.
installation instructions to the future owner. They contain information vital to
the continued safe use of the product.
To the New Owner
Important: Retain these instructions with your Owner's/Operator's Manual. They contain installation information for reference.
Refer to the appropriate Service Manual of the model being serviced for disassembly of gearcase. Refer to the Service Manual for "ES" and newer models for reassembly and testing of gearcase.
Remove and discard original bearing housing assembly (A), retaining rings (B), retainer plate (C), four screw and seal assemblies (D), anode screws (F) and damaged gearcase. Reuse or replace anode (E) as appropriate.
Use the bearing housing O-ring, the two anode attachment screws, six gearcase attachment screws and one washer supplied in kit.