Steering Link KitCrowley Marine
These instructions will alter you to certain things you should do very carefully. If you don't, you could...
- hurt yourself or bystanders
- hurt boat operator, passengers
- damage the machinery
Safety symbol, , appears next to information important to prevent you and others from being hurt.
Note symbol, Note, appears next to information important to keep machinery from being damaged.
IMPORTANT: The important safeguards and instructions appearing in these
directions cannot cover all possible conditions or situations that occur. The
person following these directions must use common sense, caution and care.
Product Reference & Illustration
When reference is made to brand name, product or specific tool, an equivalent product may be used in place of the referred to product. Substitute products used must have equivalent characteristics, including type, strength, and material. Incorrect substitution may result in product malfunction and possible injury to the operator and/or passengers.
All photographs and illustrations used may not necessarily depict actual models or equipment, but are intended only for reference. Specifications used are based on the latest product information available at the time of publication.
TO THE OWNER: The assembly procedures outlined in this sheet should be
performed by a skilled technician. If you have questions, see your DEALER. Save
these instructions in your owner's kit. The sheet contains information important
to the future use and maintenance of your engine.
Port entry steering: Lay motor on work bench. Remove the port tilt tube locknut (A). Have someone hold carrying handle (B) and return spring (C) (behind handle) in position as you pull out tilt tube.
! Install tilt tube in the opposite direction. Spring must hold carrying handle DOWN. Thread locknut (A) onto tilt tube. Torque locknut to 50-54 ft. lbs. (68-73 Nm) and loosen 1/4 revolution. Make sure a minimum of 5/8 in. thread (D) is exposed for attaching steering cable anchor nut.
Replace any locknut if its locking feature becomes
weak. Definite resistance to tightening must be felt when reusing a locknut.
Steering link installation: The instructions illustrate a starboard entry steering link. Port entry steering link installation would be a mirror image. Mount motor on transom.
Lubricate and install steering cable and tighten anchor nut (A) following steering manufacturer's instructions.
Align steering link (B) with steering cable ram and engine steering arm.
Position washers (C) above and below steering cable ram.
Install locknut (D). Torque to 7-8 ft. lbs. (8-11 Nm) and loosen locknut 1/8 revolution.
Hold locknut (E) in cavity under steering arm.
Thread steering link screw (F) into locknut. Torque to 10-12 ft. lbs. (14-16 Nm).