Gasket Kit P/N 393561Crowley Marine
These installation instructions contain information that can help prevent personal injury and damage to equipment. Understand the following symbols before proceeding:
(Safety Warning): Alerts you to the possibility of danger and identifies information that will help prevent injuries.
Note: Identifies information that will help prevent damage to machinery.
Important: Appears next to information that controls correct
assembly and operation of the product.
TO THE OWNER
the assembly procedures outlined in this sheet should be performed by a
skilled technician. If you have questions, see your DEALER. Save these
instructions in your owner's kit. This sheet contains information important to
the future use and maintenance of your engine.
TO THE INSTALLER
Give this sheet to the owner. Advise the owner of any special operation or
maintenance information contained in the instructions.
This exhaust gasket is used on 235 outboard and 2.6 Liter OMC Sea Drive® Models.
Use the exhaust gasket as supplied to service cylinder blocks without water passage O-rings.
Inspect your powerhead, if the cylinder block has water passage O-rings (A) the gasket must be modified.
Cut out template.
Align the template arrows (B) with lower edge of gasket and hold in position. Mark gasket with felt pen and cut with scissors.
Hold the gasket against the cylinder block and make sure gasket does not interfere with O-rings.